Wall-Champ Installation

Requirements:
Damp rag or cloth
1 pair of hands for small, 2 pairs of hands for large
Smooth, flat wall

Not following these directions will result in poor application and poor adhesion to your wall. This will not constitute a refund or reprint.

• Keep box/roll for future storage
• Unroll your Wall-Champ and lay it flat on the floor. Allow 10 – 15 minutes to adjust to room temperature.
  
• Find a good spot for your Wall-Champ. Pick a smooth flat wall. Clean the wall with a damp cloth and dry thoroughly. Wall-Champ will not stick to textured, dirty, stained or wet walls.
• Do Not Use any soaps, household detergents, or other chemicals, before installation. Just use a Damp Cloth or Rag. Otherwise you may damage the adhesive.
• Remove Wall-Champ from its backing. Do not discard backing paper, put it back into the tube or box. You’ll thank us later for this tip.
• Starting in the middle and working toward the edges, stick your Wall-Champ to the wall. Avoid touching the adhesive, your body produced natural oils and can harm the adhesive. It’s ok if it touches it self. Pull it apart slowly and continue.
• You can now push out any bubbles working from the inside out. If you have a huge bubble, pull up the closest edge, and lay it back down. If your happy with its position, push firmly on it to make sure it sticks. You can also use the squeegee, if one was provided, to go over your Wall-Champ a few times, the more the better. Take great care on the edges pushing firmly. If one curls up, push it back down.
• If you do not like your Wall-Champ new home, carefully pull it back up and start over in a new spot.
  
• If you are moving to a new home, or changing the Wall-Champ to a new location, put it on the backing paper it came with. If you no longer have it, use wax paper on the back of it.
• If treated properly, your Wall-Champ will last many, many moons. If you are having trouble, please email us at: http://wallchamp.com/contact_us.php
• or call: 570-208-2528